DIY Fabric Storage Bins for Tall Bolts
I have many tall bolts of fabric for my business, and I stick them along the walls, bracketed by bookshelves – but this is really inefficient – they slide, shift, and fall; they take up lots of space, and it’s difficult to move them. I’ve been wanting a professional solution, but it’s been SHOCKINGLY hard to find anything, even the nicely wheely bins that JoAnn Fabrics has – even from store fitting companies!! JoAnn Fabrics is, of course, supplied by their HQ so they have no idea where it comes from or where to buy….
The one thing I could find on the market (which I can’t show you, because it seems to be discontinued), was close to $1,000…. not ideal…. Ok, let’s be real, not even remotely in my budget!
SO! My awesome husband designed and built rolling bins for me that I can also use for my booth at Sew Expo!!
Total Cost: About $150 Total Time: About 6 hours – including shopping for lumber and having it cut
I was bad and didn’t take in process photos – largely because he built it while I wasn’t around, but also because I’m bad at this blogging thing 😉 (mea culpa)
So, the big thing was that the inside of the box be smooth and safe for the fabric, and the easiest way to make sure of that was to totally line the inside of the wooden box with a cardboard box. We had some 4.5 moving boxes left over from our move, and they are about 18″ x 24″ and about 18″ tall – these were almost the same dimensions as the JoAnn Fabric bins, so they were perfect – and with the flaps up, the sides come up to the right height and the wooden boxes become totally fabric-safe!
The sides are framed in with 2x4s – Home Depot did all the cutting for us – so things are not quite perfectly aligned, but close enough. We used corner brackets for the frame for extra stability – these were the single most expensive part of the project. We used self-drilling screws to make our life easier – you don’t have to pre-drill the holes, just sink the screws in. The sides are 1/4″ OSB (oriented strand board), and I covered the sides with a roll of heavy wallpaper I had gotten from the free bin of a design store that just wanted this partial roll leftover from a project gone.
The bottoms are 1/2″ OSB, heavily screwed together, and then there are 4 small wheels – 1 at each corner – fully swiveling, non-braking, 90lb-bearing. These are only screwed in at 3 holes, since the forth screw would be in the middle of the floor, and thus in our way…
We will be mounting big thick handles on the sides to make it easier to move and lift.
You like my pretty shabby chic industrial-look fabric storage bins??!!
These instructions are a bit rough, so if you have any questions, please let me know!!